Item No.: D11
Model: Diving Torch
Brightness: Max 1000 lumens
Bulb: CREE XM-L2 LED,
The lifespan of LED: About 50,000 hrs
Color Temperature of LED: 6500k
Three Brightness Levels: High(100%)>Low(30%)>Strobe
Runtime: High: 2.0 hrs Low: 8.2 hrs
Body Material: Durable Aircraft-grade Aluminum
Angle of Light Beam: 5°light centre beam,110°light periphery beam.
Surface Treatment: Premium alloy with type III hard anodization for
resisting seawater erosion.
Body Color: Black/ Blue
Lens: 4mm clear PC
Battery: 18650 Li-ion Battery* 2.
With battery over-discharging protection, polarity reversing
Operation Voltage: 5.6 to 8.4V
Waterproof: 100 Meters Underwater/IP68
Impact Resistance: 1.5 M
Net Weight: 277 Grams (w/o battery), 369 Grams (w/battery),Under
seawater: 197 Grams (w/batte
Dimensions: 234(L)x24.5(body dia.)x57(head dia.)mm
Switch: Tail switch
Operation: Repeated rotation tail within one second to cycle
through 3 modes.
1. The Diving Light with special fixture.It would be damaged if
disassembled at your own discretion.
2. Pl inspect the O-rings carefully every time you finished diving
and change the broken O-rings when necessary.
3. After every diving,pl clean the flashlight body with fresh
water,and store it properly after full dried.
1. Remove the tail by turning counter-clockwise.
2. Remove used batteries and replace with fresh batteries as shown
by the polarity stickers.
3. Mount the tail by turning clockwise.DO NOT ACTIVATE IT YET.
1. Plug the charger in the wall power socket, the indicator light
is green in the free-load status.
2. Put the battery in the slot of the charger.
3. The indicator light is red if the batter is not fully charged;
It will turn green after fully charged.
4.Take out the fully charged battery and use them in the diving
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring
or mating lens surface as this can cause the light to flood under
pressure. Remove any salt deposits, sand, dirt, or other foreign
matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.
If the light is not to be used for sometime,remove the batteries to
prevent possible leakage or corrosion.Pl remove the batteries
during transportation to prevent it from incorrect operation
WARRANTY: One Year